Datasheet LT1959 (Analog Devices)

HerstellerAnalog Devices
Beschreibung4.5A, 500kHz Step-Down Switching Regulator
Seiten / Seite24 / 1 — FEATURES. DESCRIPTIO. Operates with Input as Low as 4V. Output Range Down …
Dateiformat / GrößePDF / 305 Kb
DokumentenspracheEnglisch

FEATURES. DESCRIPTIO. Operates with Input as Low as 4V. Output Range Down to 1.21V. Constant 500kHz Switching Frequency

Datasheet LT1959 Analog Devices

Modelllinie für dieses Datenblatt

Textversion des Dokuments

LT1959 4.5A, 500kHz Step-Down Switching Regulator
U FEATURES DESCRIPTIO

Operates with Input as Low as 4V
The LT®1959 is a 500kHz monolithic buck mode switching ■
Output Range Down to 1.21V
regulator functionally identical to the LT1506 but optimized ■
Constant 500kHz Switching Frequency
for lower output voltage applications. It will operate down ■
Uses All Surface Mount Components
to 1.21V output compared to 2.42V for the LT1506. A 4.5A ■
Inductor Size Reduced to 1.8
µ
H
switch is included on the die along with all the necessary ■ Saturating Switch Design: 0.07Ω oscillator, control and logic circuitry. High switching fre- ■ Shutdown Current: 15µA quency allows a considerable reduction in the size of ex- ■ Easily Synchronizable ternal components. The topology is current mode for fast ■ Cycle-by-Cycle Current Limiting transient response and good loop stability. ■ 4.5A Switch A special high speed bipolar process and new design tech- ■ Current Mode Control niques achieve high efficiency at high switching frequency.
U
Efficiency is maintained over a wide output current range
APPLICATIO S
by keeping quiescent supply current to 3.8mA and by uti- lizing a supply boost capacitor to saturate the power switch. ■ Portable Computers ■ Battery-Powered Systems The LT1959 fits into standard 7-pin DD and fused lead ■ Battery Chargers SO-8 packages. Full cycle-by-cycle short-circuit protection ■ Distributed Power and thermal shutdown are provided. Standard surface ■ 5V to 3.3V Conversion mount external parts are used, including the inductor and ■ 5V to 2.5V Conversion capacitors. There is the optional function of shutdown or ■ 5V to 1.8V Conversion synchronization. A shutdown signal reduces supply current to 15µA. Synchronization allows an external logic level sig- nal to increase the internal oscillator from 580kHz to 1MHz. , LTC and LT are registered trademarks of Linear Technology Corporation.
U TYPICAL APPLICATION Efficiency vs Load Current 5V to 1.8V Down Converter
90 VOUT = 3.3V D2 VIN = 5V 1N914 L = 10µH 85 C2 0.68µF L1 BOOST 5µH OUTPUT INPUT 80 VIN V 1.8V 5V SW C3 R1 4A OPEN + LT1959 10µF TO EFFICIENCY (%) OR 1.21k 50µF SHDN FB HIGH 75 CERAMIC C1 = ON GND VC + R2 100µF, 10V CC D1 2.49k SOLID 1.5nF MBRS330T3 TANTALUM 70 0 0.5 1.0 1.5 2.0 2.5 3.0 3.5 4.0 1959 TA01 LOAD CURRENT (A) 1959 TA02 1