Datasheet LTC1922-1 (Analog Devices) - 3

HerstellerAnalog Devices
BeschreibungSynchronous Phase Modulated Full-Bridge Controller
Seiten / Seite24 / 3 — ELECTRICAL CHARACTERISTICS The. denotes the specifications which apply …
Dateiformat / GrößePDF / 316 Kb
DokumentenspracheEnglisch

ELECTRICAL CHARACTERISTICS The. denotes the specifications which apply over the full operating

ELECTRICAL CHARACTERISTICS The denotes the specifications which apply over the full operating

Modelllinie für dieses Datenblatt

Textversion des Dokuments

LTC1922-1
ELECTRICAL CHARACTERISTICS The

denotes the specifications which apply over the full operating temperature range, otherwise specifications are at VCC = 9.5V, CT = 180pF, TA = TMIN to TMAX unless other wise noted. SYMBOL PARAMETER CONDITIONS MIN TYP MAX UNITS Oscillator
OSCT Total Variation VCC = 6.5V to 9.5V ● 236 277 319 kHz OSCV CT RAMP Amplitude Measured on CT 3.6 3.85 4.2 V OSYT SYNC Threshold Measured on SYNC 1.6 1.8 2.2 V OSYW Minimum SYNC Pulse Width Measured at Outputs (Note 2) 6 ns OSYWX Maximum SYNC Pulse Width Measured on Outputs, CT = 180pF 1.3 µs OSOP SYNC Output Pulse Width Measured on SYNC, RSYNC = 5.1k 170 ns
Error Amplifier
VFB FB Input Voltage COMP = 2.5V (Note 3) 1.179 1.204 1.229 V FBI FB Input Range Measured on FB (Note 4) –0.3 2.5 V AVOL Open-Loop Gain COMP = 1V to 3V (Note 3) 70 90 dB IIB Input Bias Current COMP = 2.5V (Note 3) 5 50 nA VOH Output High Load on COMP = –100µA 4.7 4.92 V VOL Output Low Load on COMP = 100µA 0.18 0.4 V ISOURCE Output Source Current COMP = 2.5V – 400 – 800 µA ISINK Output Sink Current COMP = 2.5V 3 7 mA
Reference
VREF Initial Accuracy TA = 25°C, Measured on VREF 4.925 5 5.075 V REFTV Total Variation Line, Load and Temperature ● 4.9 5 5.1 V REFLD Load Regulation Load on VREF = 100µA to 5mA 2 15 mV REFLN Line Regulation VCC = 6.5V to 9.5V 0.1 10 mV REFSC Short-Circuit Current VREF Shorted to GND 18 30 45 mA
Outputs
OUTH(X) Output High Voltage IOUT(X) = –50mA 7.9 8.4 V OUTL(X) Output Low Voltage IOUT(X) = 50mA 0.6 1 V RHI(X) Pull-Up Resistance IOUT(X) = –50mA to –10mA 22 30 Ω RLO(X) Pull-Down Resistance IOUT(X) = –50mA to –10mA 12 20 Ω tr(X) Rise Time COUT(X) = 50pF 5 15 ns tf(X) Fall Time COUT(X) = 50pF 5 15 ns
Current Limit and Shutdown
CLPP Pulse-by-Pulse Current Limit Threshold Measured on CS 0.34 0.415 0.48 V CLSD Shutdown Current Limit Threshold Measured on CS 0.55 0.64 0.73 V SSI Soft-Start Current SS = 2.5V 7 12 17 µA SSR Soft-Start Reset Threshold Measured on SS 0.7 0.4 0.1 V FLT FAULT Reset Threshold Measured on SS 4.4 4.1 3.8 V
Note 1:
Absolute Maximum Ratings are those values beyond which the life
Note 4:
Set FB to –0.3V, 2.5 and insure that COMP does not phase invert. of a device may be impaired.
Note 5:
The LTC1922-1E is guaranteed to meet performance specifications
Note 2:
SYNC pulse width is valid from >20ns and <0.4 • (1/fOSC), from 0°C to 85°C. Specification over the –40°C to 85°C operating VSYNC = 0V to 5V. temperature range are assured by design, characterization and correlation
Note 3:
FB is driven by a servo loop amplifier to control V with statistical process controls. The LTC1922-1I is guaranteed and tested COMP for these tests. over the – 40°C to 85°C operating temperature range. 3