Datasheet Texas Instruments TPS61090RSAR — Datenblatt

HerstellerTexas Instruments
Datasheet Texas Instruments TPS61090RSAR

2A-Schalter, 96% effizienter Aufwärtswandler 16-QFN -40 bis 85


TPS6109x Synchronous Boost Converter With 2-A Switch datasheet
PDF, 1.0 Mb, Revision: C, Datei veröffentlicht: Dec 24, 2014
Auszug aus dem Dokument



Lifecycle StatusActive (Recommended for new designs)
Manufacture's Sample AvailabilityYes


Package TypeRSARSA
Package QTY30003000
Device Marking1090TPS6
Width (mm)44
Length (mm)44
Thickness (mm).9.9
Pitch (mm).65.65
Max Height (mm)11
Mechanical DataHerunterladenHerunterladen


Duty Cycle(Max)100 %
Iq(Typ)0.02 mA
Operating Temperature Range-40 to 85 C
Package GroupQFN
Regulated Outputs1
Special FeaturesEnable,Frequency Synchronization,Light Load Efficiency,Load Disconnect,Power Good
Switch Current Limit(Min)2 A
Switch Current Limit(Typ)2 A
Switching Frequency(Max)700 kHz
Switching Frequency(Min)500 kHz
Vin(Max)5.5 V
Vin(Min)1.8 V
Vout(Max)5.5 V
Vout(Min)1.8 V



Design Kits und Evaluierungsmodule

  • Evaluation Modules & Boards: TPS61090EVM-029
    TPS61090 Evaluation Module
    Lifecycle Status: Active (Recommended for new designs)
  • Evaluation Modules & Boards: TPS61070EVM-062
    TPS61070 Evaluation Module
    Lifecycle Status: Active (Recommended for new designs)


  • Powering a White LED Flashlight with the TPS61090
    PDF, 74 Kb, Datei veröffentlicht: May 23, 2005
    This application report details how to drive a 3-W white LED from a single lithium-ion battery using the Texas Instruments TPS61090 low-power dc-dc boost converter to achieve efficiencies >90%. Design considerations and equations needed for driving a single, multiple-watt white LED are covered including efficiency improvements, peak switch current calculations, and a soft-start considerations.
  • Automated Frequency Response Analyzer
    PDF, 939 Kb, Datei veröffentlicht: Oct 9, 2013
    This application report discusses a new method of doing stability Analysis testing by using basic labequipment, while not requiring any specific instruments.
  • Five Steps to a Good PCB Layout of the Boost Converter
    PDF, 701 Kb, Datei veröffentlicht: May 3, 2016
  • Minimizing Ringing at the Switch Node of a Boost Converter
    PDF, 201 Kb, Datei veröffentlicht: Sep 15, 2006
    The application report explains how to use proper board layout and/or a snubber to reduce high-frequency ringing at the switch node of a boost converter.
  • Design considerations for a resistive feedback divider in a DC/DC converter
    PDF, 393 Kb, Datei veröffentlicht: Apr 26, 2012
  • Basic Calculation of a Boost Converter's Power Stage (Rev. C)
    PDF, 186 Kb, Revision: C, Datei veröffentlicht: Jan 8, 2014
    This application note gives the equations to calculate the power stage of a boost converter built with an IC with integrated switch and operating in continuous conduction mode. It is not intended to give details on the functionality of a boost converter (see Reference 1) or how to compensate a converter. See the references at the end of this document if more detail is needed.
  • Optimizing Transient Response of Internally Compensated DC-DC Converters (Rev. A)
    PDF, 1.1 Mb, Revision: A, Datei veröffentlicht: May 11, 2015
  • Extending the Soft Start Time Without a Soft Start Pin (Rev. B)
    PDF, 387 Kb, Revision: B, Datei veröffentlicht: Jun 15, 2017
  • Choosing an Appropriate Pull-up/Pull-down Resistor for Open Drain Outputs
    PDF, 130 Kb, Datei veröffentlicht: Sep 19, 2011
  • QFN and SON PCB Attachment (Rev. B)
    PDF, 821 Kb, Revision: B, Datei veröffentlicht: Aug 24, 2018
  • IQ: What it is what it isn’t and how to use it
    PDF, 198 Kb, Datei veröffentlicht: Jun 17, 2011
  • Performing Accurate PFM Mode Efficiency Measurements (Rev. A)
    PDF, 418 Kb, Revision: A, Datei veröffentlicht: Dec 11, 2018
    When performing measurements on DC-DC converters using pulse frequency modulation(PFM)or any power save mode proper care must be taken to ensure that the measurements are accurate. An accurate PFM mode efficiency measurement is critical for systems which require high efficiency at low loads such as in smart home systems tablets wearables and metering.


Serie: TPS61090 (2)


  • Semiconductors > Power Management > Non-isolated DC/DC Switching Regulator > Step-Up (Boost) > Boost Converter (Integrated Switch)