Datasheet Texas Instruments DP83620SQX/NOPB — Datenblatt

HerstellerTexas Instruments
SerieDP83620
ArtikelnummerDP83620SQX/NOPB
Datasheet Texas Instruments DP83620SQX/NOPB

Industrial Temp Single Port 10/100 Mbit / s Eth Phys Layer Transceiver mit Glasfaserunterstützung 48-WQFN -40 bis 85

Datenblätter

Industrial Temp Single Port 10/100 Mbps Ethernet PHY Xceiver w/Fiber Support datasheet
PDF, 1.3 Mb, Revision: C, Datei veröffentlicht: Apr 15, 2013
Auszug aus dem Dokument

Preise

Status

Lifecycle StatusActive (Recommended for new designs)
Manufacture's Sample AvailabilityYes

Verpackung

Pin48
Package TypeRHS
Industry STD TermWQFN
JEDEC CodeS-PQFP-N
Package QTY2500
CarrierLARGE T&R
Device MarkingDP83620SQ
Width (mm)7
Length (mm)7
Thickness (mm).75
Pitch (mm).5
Max Height (mm).8
Mechanical DataHerunterladen

Parameter

Cable Length150 m
Datarate10/100 Mbps
FunctionPHY
InterfaceMII,RMII
JTAG1149.1Yes
Operating Temperature Range-40 to 85 C
Package GroupWQFN
Package Size: mm2:W x L48WQFN: 49 mm2: 7 x 7(WQFN) PKG
Port CountSingle
RatingCatalog
Special FeaturesFX Support,Cable Diagnostics
Supply Voltage3.3 Volt

Öko-Plan

RoHSCompliant

Design Kits und Evaluierungsmodule

  • Evaluation Modules & Boards: DP83620-EVK
    DP83620 Evaluation Demo Board
    Lifecycle Status: Active (Recommended for new designs)

Anwendungshinweise

  • AN-1469 PHYTERВ® Design & Layout Guide (Rev. D)
    PDF, 289 Kb, Revision: D, Datei veröffentlicht: Apr 26, 2013
    This application report describes PHYTERв„ў design and layout guidelines.
  • AN-1794 Using RMII Master Mode (Rev. A)
    PDF, 63 Kb, Revision: A, Datei veröffentlicht: Apr 26, 2013
    Texas Instruments PHYTERВ® family of products incorporate the Reduced Media Independent Interface (RMII) as described in the RMII revision 1.2 specification from the RMII Consortium. This interface may be used to connect a PHY device to a MAC in 10/100 Mb/s systems using a reduced number of pins relative to standard MII. In this mode, data is transferred two bits at a time using a 50 MHz refere
  • Improving Electro-Magnetic Noise Immunity in Serial Communications Systems (Rev. A)
    PDF, 60 Kb, Revision: A, Datei veröffentlicht: Apr 26, 2013
    This application note provides key recommendations for implementing serial communication systems that exceed IEC immunity test standards. To provide an example of highly reliable serial communications system implementation and testing, a Texas Instruments DP83640 Ethernet Physical Layer device was tested for International Electrotechnical Commission (IEC) immunity test compliance. Results from the
  • DP83640 Synchronous Ethernet Mode: Achieving Sub-ns Accuracy in PTP Applications (Rev. A)
    PDF, 757 Kb, Revision: A, Datei veröffentlicht: Apr 26, 2013
    This application note first provides a summary of empirical results found when master to slave node synchronization is measured with Synchronous Ethernet mode enabled. Background information is then provided describing the operation of and topological constraints associated with Synchronous Ethernet mode. Typical applications are then described, followed by empirical data which clearly demonstrate
  • Reducing Radiated Emissions in Ethernet 10/100 LAN Applications (Rev. A)
    PDF, 70 Kb, Revision: A, Datei veröffentlicht: Apr 26, 2013
    This application report explains how Texas Instruments' PHYTER products help system designers toreduce radiated emissions in Ethernet 10/100 LAN applications.
  • AN-1540 Power Measurement of Ethernet Physical Layer Products (Rev. B)
    PDF, 79 Kb, Revision: B, Datei veröffentlicht: Apr 26, 2013
    System designers require accurate component power consumption specifications, for the purposes of thermal management, component selection, and power distribution planning.
  • AN-1548 PHYTER 100 Base-TX Reference Clock Jitter Tolerance (Rev. B)
    PDF, 126 Kb, Revision: B, Datei veröffentlicht: Apr 26, 2013
    The use of a reference clock that is less stable than those directly driven from an oscillator may be required for some applications. In addition, some customer applications may require partnering with devices that operate outside of the IEEE 802.3 standard for transmitted jitter.

Modellreihe

Serie: DP83620 (3)

Herstellerklassifikation

  • Semiconductors > Interface > Ethernet > Ethernet PHY