Datasheet Texas Instruments CC1101-Q1 — Datenblatt

HerstellerTexas Instruments
SerieCC1101-Q1
Datasheet Texas Instruments CC1101-Q1

Kostengünstiger Low-Power-Sub-1-GHz-HF-Transceiver

Datenblätter

Low-Power Sub-1-GHz Fractional-N UHF Device Family for Automotive datasheet
PDF, 1.6 Mb, Revision: B, Datei veröffentlicht: Apr 16, 2010
Auszug aus dem Dokument

Preise

Status

CC1101QRHBRG4Q1
Lifecycle StatusActive (Recommended for new designs)
Manufacture's Sample AvailabilityNo

Verpackung

CC1101QRHBRG4Q1
N1
Pin32
Package TypeRHB
Industry STD TermVQFN
JEDEC CodeS-PQFP-N
Package QTY3000
Device MarkingQQ1
Width (mm)5
Length (mm)5
Thickness (mm).9
Pitch (mm).5
Max Height (mm)1
Mechanical DataHerunterladen

Parameter

Parameters / ModelsCC1101QRHBRG4Q1
CC1101QRHBRG4Q1
Data Rate(Max), kbps250
Device TypeUHF Transceiver
Frequency Bands, MHz315,433,779,868,915,920
Operating Temperature Range, C-40 to 125
RX Current (Lowest), mA15.5
RatingAutomotive
Sensitivity (Best), dBm-114
Special FeaturesAEC-Q100 Grade 1/125В°C
TX Power(Max), dBm12
TechnologySub-1 GHz
Throughput(Max), Mbps0.6

Öko-Plan

CC1101QRHBRG4Q1
RoHSCompliant

Anwendungshinweise

  • DN013 -- Programming output powers on CC1101 (Rev. A)
    PDF, 238 Kb, Revision: A, Datei veröffentlicht: Jan 2, 2008
  • DN010 -- Close-in Reception with CC1101 (Rev. B)
    PDF, 102 Kb, Revision: B, Datei veröffentlicht: Jul 21, 2009
  • Resonant Trimming Sequence
    PDF, 88 Kb, Datei veröffentlicht: Jan 9, 2013
    This application report presents an efficient and precise method on how to achieve the desired resonant frequency of configuring the trim array with only a few iterations and measuring the resonant frequency. First, the minimum and maximum resonant frequency is measured; from this data a capacitance gradient is derived, which allows a good prediction of the required capacitance. The calculated cap
  • DN017 -- CC11xx 868/915 MHz RF Matching (Rev. A)
    PDF, 328 Kb, Revision: A, Datei veröffentlicht: Mar 31, 2008
    There are three versions of the CC11xx reference design which have been published. This design note gives a short introduction to RF matching and important aspects when designing products using the CC11xx parts and discusses the differences between the three reference design revisions.
  • AN072 -- Using the TAI-SAW TA0801A SAW Filter and External PA (Rev. A)
    PDF, 359 Kb, Revision: A, Datei veröffentlicht: Aug 19, 2009
  • AN050 -- Using the CC1101 in the European 868MHz SRD band (Rev. B)
    PDF, 223 Kb, Revision: B, Datei veröffentlicht: Sep 11, 2009
  • DN501 -- PATABLE Access (Rev. B)
    PDF, 66 Kb, Revision: B, Datei veröffentlicht: Mar 24, 2009
  • DN500 -- Packet Transmission Basics (Rev. C)
    PDF, 174 Kb, Revision: C, Datei veröffentlicht: Apr 6, 2009
  • DN503 -- SPI Access (Rev. B)
    PDF, 94 Kb, Revision: B, Datei veröffentlicht: Oct 22, 2007
    The purpose of this design note is to show how the serial peripheral interface (SPI) must be configured to be able to communicate with the CC1100/CC1101/CC1150/CC2500/CC2550. It also shows how the status bytes should be interpreted and how SW reset is done over the SPI interface.
  • DN111 - Current Consumption for a Polling Receiver (Rev. A)
    PDF, 687 Kb, Revision: A, Datei veröffentlicht: Mar 24, 2009
  • DN505 -- RSSI interpretation and timing (Rev. D)
    PDF, 129 Kb, Revision: D, Datei veröffentlicht: Jun 16, 2010
  • DN506 -- GDO Pin Usage (Rev. A)
    PDF, 219 Kb, Revision: A, Datei veröffentlicht: Oct 22, 2007
    The purpose of this design note is to explain how to use the different general digital output (GDO) pins for control and monitoring purposes. The focus is set on interfacing with a microcontroller unit (MCU) and is related to the CC1100, CC1101, CC1150, CC2500 and CC2550 devices.
  • DN005 -- CC11xx Sensitivity versus Frequency Offset and Crystal Accuracy (Rev. C)
    PDF, 96 Kb, Revision: C, Datei veröffentlicht: Aug 20, 2009
  • DN022 -- CC110x CC111x OOK ASK Register Settings (Rev. E)
    PDF, 532 Kb, Revision: E, Datei veröffentlicht: Mar 8, 2012
  • DN504 -- FEC Implementation (Rev. A)
    PDF, 110 Kb, Revision: A, Datei veröffentlicht: Oct 22, 2007
    This design note explains the functionality of forward error correction (FEC) and how it is used in the CC1100, CC1101, CC1110, CC1111, CC1150, CC2500, CC2510, CC2511, and CC2550 devices. Example code for FEC implementation is included.
  • DN016 -- Compact Antenna Solution for 868/915 MHz (Rev. B)
    PDF, 832 Kb, Revision: B, Datei veröffentlicht: Aug 20, 2009
  • DN502 -- CRC Implementation (Rev. D)
    PDF, 55 Kb, Revision: D, Datei veröffentlicht: Oct 27, 2009
  • DN024 -- 868 MHz, 915 MHz and 955 MHz Monopole PCB Antenna (Rev. E)
    PDF, 1.0 Mb, Revision: E, Datei veröffentlicht: Feb 22, 2013
  • DN033 - Mitsubishi Ceramic Antenna for 868 MHz, 915 MHz & 955 (Rev. A)
    PDF, 685 Kb, Revision: A, Datei veröffentlicht: Sep 14, 2010
  • DN023 -- 868 MHz, 915 MHz and 955 MHz Inverted F Antenna (Rev. C)
    PDF, 369 Kb, Revision: C, Datei veröffentlicht: Aug 30, 2011

Modellreihe

Serie: CC1101-Q1 (1)

Herstellerklassifikation

  • Semiconductors> Wireless Connectivity> Companion Wireless Solutions> Smart RF Transceivers