Datasheet Texas Instruments OPA637APG4 — Datenblatt

HerstellerTexas Instruments
SerieOPA637
ArtikelnummerOPA637APG4
Datasheet Texas Instruments OPA637APG4

Präzisions-Hochgeschwindigkeits-Difet®-Operationsverstärker 8-PDIP

Datenblätter

OPA627 and OPA637 Precision High-Speed DifetВ® Operational Amplifiers datasheet
PDF, 1.4 Mb, Revision: A, Datei veröffentlicht: Apr 16, 2015
Auszug aus dem Dokument

Preise

Status

Lifecycle StatusActive (Recommended for new designs)
Manufacture's Sample AvailabilityNo

Verpackung

Pin8
Package TypeP
Industry STD TermPDIP
JEDEC CodeR-PDIP-T
Package QTY50
CarrierTUBE
Device MarkingOPA637AP
Width (mm)6.35
Length (mm)9.81
Thickness (mm)3.9
Pitch (mm)2.54
Max Height (mm)5.08
Mechanical DataHerunterladen

Parameter

Acl, min spec gain1.7 V/V
Additional FeaturesDecompensated
ArchitectureFET,Voltage FB
BW @ Acl16 MHz
CMRR(Min)100 dB
CMRR(Typ)110 dB
GBW(Typ)80 MHz
Input Bias Current(Max)5 pA
Iq per channel(Max)7.5 mA
Iq per channel(Typ)7 mA
Number of Channels1
Offset Drift(Typ)0.4 uV/C
Operating Temperature Range-25 to 85 C
Output Current(Typ)45 mA
Package GroupPDIP
Package Size: mm2:W x LSee datasheet (PDIP) PKG
Rail-to-RailIn,Out
RatingCatalog
Slew Rate(Typ)100 V/us
Total Supply Voltage(Max)36 +5V=5, +/-5V=10
Total Supply Voltage(Min)9 +5V=5, +/-5V=10
Vn at 1kHz(Typ)5.2 nV/rtHz
Vn at Flatband(Typ)4.5 nV/rtHz
Vos (Offset Voltage @ 25C)(Max)0.1 mV

Öko-Plan

RoHSCompliant

Anwendungshinweise

  • Fast Settling Low-Pass Filter
    PDF, 101 Kb, Datei veröffentlicht: Sep 27, 2000
    Noise reduction by filtering is the most commonly used method for improving signal-to-noise ratio. The increase in settling time, however, can be a serious disadvantage in some applications such as high-speed data acquisition systems. The nonlinear filter described here is a simple way to get a four-to-one improvement in settling time as compared to a conventional filter.
  • Improved Device Noise Performance For the 3650 Isolation Amplifier
    PDF, 28 Kb, Datei veröffentlicht: Sep 27, 2000
    The 3650 is an optically coupled, differential input, isolation amplifier having programmable gain. Noise for the 3650 is specified to 4u Vrms (typ) on the input stage of the isolation barrier and 65u Vrms (typ) on the output stage. The gain of the 3650 is controlled using exernal resistors on the input stage. In low gains, the noise performance of the 3650 is dominated by the output stage noise f
  • OPA627, OPA637 EMI Immunity Performance (Rev. A)
    PDF, 90 Kb, Revision: A, Datei veröffentlicht: Nov 2, 2012
  • Composite Op Amp Gives You The Best of Both Worlds
    PDF, 32 Kb, Datei veröffentlicht: Sep 27, 2000
    Classical op amps such as the OPA627 have excellent performance in applications where the required gain bandwidth is low compared to the gain-bandwidth product of the op amp. However, increasing closed-loop gain decreases the error-reducing loop gain. Furthermore, starting at relatively low frequencies, the loop gain rolls-off at 20dB/decade of signal frequency increase. In combination these effec
  • Comparison of Noise Performance of FET Transimpedence Amp/Switched Integrator
    PDF, 66 Kb, Datei veröffentlicht: Sep 27, 2000
    Low-input current FET operational amplifiers are universlly used to monitor photodetector, or more commonly photodiode currents. These photodetectors bridge the gap between a physical event, light, and electronics. There are a variey of amplifier configurations to select from and the choice is based on noise, bandwidth, offset, and linearity. A considerable amount has been written on the performan
  • MUX-Friendly: Definition and Benefits
    PDF, 212 Kb, Datei veröffentlicht: Sep 18, 2017
  • Compensate Transimpedance Amplifiers Intuitively (Rev. A)
    PDF, 69 Kb, Revision: A, Datei veröffentlicht: Mar 30, 2005
    Transimpedance amplifiers are used to convert low-level photodiode currents to usable voltage signals. All too often, the amplifiers have to be empirically compensated to operate properly. The problem can be easily understood if one looks at all the elements involved.
  • Noise Analysis for High Speed Op Amps (Rev. A)
    PDF, 256 Kb, Revision: A, Datei veröffentlicht: Jan 17, 2005
    As system bandwidths have increased an accurate estimate of the noise contribution for each element in the signal channel has become increasingly important. Many designers are not however particularly comfortable with the calculations required to predict the total noise for an op amp or in the conversions between the different descriptions of noise. Considerable inconsistency between manufactu

Modellreihe

Herstellerklassifikation

  • Semiconductors > Amplifiers > Operational Amplifiers (Op Amps) > High-Speed Op Amps (>=50MHz)