Datasheet Texas Instruments UCC28250RGPR — Datenblatt

HerstellerTexas Instruments
SerieUCC28250
ArtikelnummerUCC28250RGPR
Datasheet Texas Instruments UCC28250RGPR

Erweiterter PWM-Controller mit Pre-Bias-Betrieb 20-QFN -40 bis 125

Datenblätter

UCC28250 Advanced PWM Controller With Prebias Operation datasheet
PDF, 1.8 Mb, Revision: D, Datei veröffentlicht: Jun 28, 2015
Auszug aus dem Dokument

Preise

Status

Lifecycle StatusActive (Recommended for new designs)
Manufacture's Sample AvailabilityNo

Verpackung

Pin20
Package TypeRGP
Industry STD TermVQFN
JEDEC CodeS-PQFP-N
Package QTY3000
CarrierLARGE T&R
Device Marking28250
Width (mm)4
Length (mm)4
Thickness (mm).93
Pitch (mm).5
Max Height (mm)1
Mechanical DataHerunterladen

Parameter

Control MethodCurrent,Voltage
Duty Cycle(Max)100 %
Frequency(Max)1000 kHz
Frequency(Min)40 kHz
Gate Drive(Typ)0.2 A
Operating Temperature Range-40 to 125 C
Package GroupQFN
RatingCatalog
Special FeaturesHV Start-up
TopologyForward,Full-Bridge,Half-Bridge,Push-Pull
UVLO Thresholds On/Off4.3/4.1 V
Vin(Max)20 V
Vin(Min)4.3 V

Öko-Plan

RoHSCompliant

Design Kits und Evaluierungsmodule

  • Evaluation Modules & Boards: UCC28250EVM-564
    Evaluation Module for UCC28250 Adv.PWM Controller w/ Pre-biased Load Op. on Secondary Side Control
    Lifecycle Status: Active (Recommended for new designs)
  • Evaluation Modules & Boards: UCC28250EVM-501
    Evaluation Module for UCC28250 Advanced PWM Controller on Primary Side Control
    Lifecycle Status: Active (Recommended for new designs)

Anwendungshinweise

  • Designing UCC28250 as a Secondary Side Control with a Pre-Bias Condition
    PDF, 395 Kb, Datei veröffentlicht: Nov 24, 2010
    This application note addresses the considerations for using the UCC28250 as a secondary side controller. With voltage mode control, the UCC28250 can be used in a design that produces smooth turn-on performance with an output pre-bias condition. The design guidelines are summarized from various performance tests and examined particularly on a 100-W, dc-dc half bridge converter. This converter is d
  • Differences Between the UCC28251 and UCC28250 and Evaluation of the UCC28251 in (Rev. A)
    PDF, 36 Kb, Revision: A, Datei veröffentlicht: Feb 15, 2013
    The UCC28251 is a functional variant of the UCC28250 PWM Controller. While the same basic functionality of the UCC28250 is largely maintained, the UCC28251 is designed to operate at a lower frequency (minimum of 27 kHz when programmed by RT pin) allowing operation in 400-V input DC-to-DC converters in off-line AC-to-DC power supplies, where frequency-dependent high-voltage switching lossesare an

Modellreihe

Serie: UCC28250 (4)

Herstellerklassifikation

  • Semiconductors > Power Management > Offline and Isolated DC/DC Controllers and Converters > PWM and Resonant Controller