Datasheet Texas Instruments THS6043ID — Datenblatt

HerstellerTexas Instruments
SerieTHS6043
ArtikelnummerTHS6043ID
Datasheet Texas Instruments THS6043ID

350-mA-, +/- 12-V-ADSL-CPE-Leitungstreiber mit Abschaltung 14-SOIC -40 bis 85

Datenblätter

350 mA +/-12V ADSL CPE Line Drivers datasheet
PDF, 1.6 Mb, Revision: G, Datei veröffentlicht: Dec 11, 2001
Auszug aus dem Dokument

Anwendungshinweise

  • Active Output Impedance for ADSL Line Drivers
    PDF, 636 Kb, Datei veröffentlicht: Nov 26, 2002
    Signal termination is very common in bidirectional communication systems. Termination allows for receiving signals while transmitting different signals at the same time. With the increasing popularity of asymmetrical digital subscriber lines (ADSL), the requirement for a low power line driver amplifier combined with line termination becomes a very difficult goal. This application note examines the
  • Wireline Data Transmission and Reception
    PDF, 191 Kb, Datei veröffentlicht: Jan 27, 2010
    Many types of wires are widely used to transmit data. Specifically, Category 3 and Category 5 (Cat3 and Cat5e, respectively)—also known as unshielded twisted pair or UTP lines—are now recommended for new telephone installations. Coaxial (coax) cables are used to distribute cable television (CATV) signals throughout a home. #12 and #14 American wire gauge (AWG) electric power distribution wire is a
  • Noise Analysis for High Speed Op Amps (Rev. A)
    PDF, 256 Kb, Revision: A, Datei veröffentlicht: Jan 17, 2005
    As system bandwidths have increased an accurate estimate of the noise contribution for each element in the signal channel has become increasingly important. Many designers are not however particularly comfortable with the calculations required to predict the total noise for an op amp or in the conversions between the different descriptions of noise. Considerable inconsistency between manufactu

Modellreihe

Herstellerklassifikation

  • Semiconductors > Amplifiers > Operational Amplifiers (Op Amps) > High-Speed Op Amps (>=50MHz)